A family roofing company serving Afton and the rest of Wisconsin through our network of local crews. Tin roofs, repairs and replacements done right.
Pick a service to see how we handle it and what the job usually looks like on a Afton roof.
One leak usually has company. We fix the one you called about and check over the rest of the roof while we are already up there.
Standing seam and metal panel roofs, measured and cut on site. We help you settle on a color, set the panels straight, and trim the ridge and valleys so the whole roof sheds water the way it should.
When a roof is genuinely finished we replace it, and we say so plainly rather than dressing it up. Metal and shingle priced side by side so you can compare real numbers.
Storm damage does not wait for business hours. We get the opening closed, photograph it for your insurance, and put the real fix on the schedule.
Small repairs get the same crew and the same care as a full roof. Free estimate, a price in writing, and the work done before the next rain moves in.
Guards installed as part of a roof job or on their own. Either way we check the hangers and the pitch while we are up there.
Wind and debris damage is not always obvious from the ground. We check the edges, the ridge, the valleys and the fasteners before telling you anything is fine.
We still shingle plenty of roofs. Cracked, curled and blown off shingles get replaced, and the valleys and flashing get reworked while we are up there.
Missing shingles get matched as close as weathering allows. Loose metal gets new fasteners and washers, and the eaves, rakes and ridge get sealed back up tight.
Where it makes sense we set low slope metal over a problem section so it finally drains instead of ponding after every rain.
Coatings for low slope and older metal roofs that are still sound but weathered. Washed down, refastened, primed at the rust, then coated.
New skylights set into metal or shingle roofs, with the flashing kit the roof actually calls for rather than a tube of sealant.
Backed out screws, split washers, rust starting at a seam, a panel lifted at the eave. These are our roofs, and most of the time a repair is all it takes.
The edge of a roof is where most trouble starts. New fascia, new soffit, wrapped or painted so it stays sound.
Slate and tile take patience and matching pieces. We replace broken and slipped units and rework the flashing they hide.
Metal, shingle and low slope work on buildings where a leak costs you more than a wet ceiling. Free estimates, same as anywhere else.
Hail bruises shingles and dents the softer metal on vents, valleys and gutters. We show you what we find and document it properly for the claim.
Removing the ice is the easy half. We also look at ventilation and insulation so it stops happening every January.
Inspections come free with an estimate. We would rather find the small problem this spring than replace a ceiling for you next winter.
The layer you never see is what keeps water out on the ugly days. We do not thin it out to save a few dollars on a bid.
Roofing Brothers began in 2002 as a family roofing company in Morganton, North Carolina, and it is still run the way it started. Homeowners in Afton reach that same outfit — the one that has been setting metal panels and laying shingles for over twenty years — through our network of local crews.
In a city the size of Afton, word travels fast about who does good work and who does not. That suits us fine. We would rather put one roof on right and have the neighbors ask about it than chase volume all over Wisconsin.
Nothing fancy — free estimates, honest answers, and roofs that go on straight.
The same family started this company putting metal roofs on neighbors houses in 2002. It has never been sold, franchised or handed off to a call center.
Beds get covered, tear off gets hauled as we go, and a magnet goes over the drive before we pull out. Your yard should look like we were never there.
Around twenty standard metal colors, and the chart comes out with the estimate so you can hold it up against your siding and shutters before you commit.
Standing seam and metal panel roofs are the work we are known for. Color, trim, fastening pattern — we have done hundreds and we will walk you through all of it.
You get a start date and we hold to it. If weather moves your job we call you, rather than leaving you watching the driveway.
Common questions from Afton, WI homeowners about metal roofs, repairs and what a roof costs.
A typical Afton shingle roof runs roughly $8,000 to $18,000 in 2026 for an average single family home, and more if the deck has rot or the roof is steep and cut up with dormers. We do not price off a satellite photo — somebody comes out and measures.
Sometimes. If the decking is sound and there is only one layer of shingles, a Afton metal roof can go over the top on purlins. If there is rot underneath or two layers already on, we tear off first — and we will tell you that before you sign, not halfway through.
For most Afton homes, yes. A metal roof costs more up front than shingles, but it usually outlives two or three shingle roofs, sheds rain and snow better, and does not peel off in a hard wind. We will price metal and shingle side by side so you can compare real numbers instead of guessing.
A metal roof installed properly on a Afton home should give you 40 to 60 years, and standing seam often goes longer because there are no exposed fasteners. Screws and sealants on a panel roof want attention around year 20, which is a small job next to a re-roof.
Most Afton metal roof jobs land somewhere between about $12,000 and $30,000 in 2026, depending on square footage, pitch, panel type and how much tear off there is. Standing seam runs higher than exposed fastener panels. We measure before we quote, and the estimate is free.
No. Estimates are always free in Afton. We come out, measure, look in the attic if we can get to it, and leave you a written price. Nobody will push you to sign anything that day, and the number does not expire in an hour.
We would rather let the work, and the people who paid for it, do the talking.
"Standing seam on our log home. The panels are dead straight and the ridge work is clean. You can tell they have done a few of these."
"Thank you so much to the entire crew at Roofing Brothers for our amazing new tin roof! You were amazing to work with and I couldn't recommend you to others enough! Great communication, pricing, color options, efficiency, and HONESTY! If anyone needs a new roof, I highly recommend this crew! Phenomenal job."
"The crew was polite, cleaned up every day, and ran a magnet over the driveway before they left. My kids never found a single nail."
Looking for a roofer just outside Afton? These areas are covered too.